Silicon Laboratories Stepper Machine User's Guide download pdf (Page 8)

The default setting, [MCU],

will debug the device on the kit. To use the on-board debug adapter to debug custom hardware, select the

[Out] option in this drop-down menu, and the debug signals will be routed to the debug header on the kit. The [In] option will enable an

external debug adapter on the debug header to debug the MCU on the board.

Note: The MCU on the board must be powered using the USB debug connector, a battery, or an external power supply when using the

[In] option.

Finally, the [MCU Information] section contains information about the MCU that is connected to the on-board debug adapter. Normally,

you will get information on the MCU on the kit, but when if debug mode is set to out, you will get information about the MCU on the

external board, instead.

More information on this tool can be found at http://www.silabs.com/simplicity-studio.

AN0822: Simplicity Studio™ User Guide

Kit Manager

silabs.com | Smart. Connected. Energy-friendly. Rev. 0.2 | 7

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

No comments

Silicon Laboratories Stepper Machine User's Guide Page 8